Hey guys. I'm having an issue with my aethers and LSP software. First off, to make a long story short, Im not getting output from my dongle when using LSP directly...so I found another way of getting my sequences on LSP to work...run the sequences through xlights. So when I'm testing my aethers through xlights, all 4 channels of both aethers are working properly. But when I run the sequence, all im getting from the aethers is red, when red comes up in the sequence. None of the other colors are working. I have the aethers set up as RGB controllers in LSP, but I have an extra channel (in lsp, i added a lynx express controller and changed it to one channel) in front of both to compensate for the 4th white channel. I wasnt sure if this was going to work, but since the reds working like it should, I dont understand why the blue and green arent working as well. I have the start channels of the aethers at 49 and 53, and like I mentioned, when testing the channels through xlights channel tester panel, the aethers are behaving properly. Any ideas?