The basic configuration looks something like this:
<--------> RGB SS Lights
PC <---network----> Etherdongle <-------> SS-HUB1<--PN(out#1)----> Zeus1 <-------> Zeus2 <-------> RGB SS Lights
<---(port 1/of/16)-----> SSC1 <---------> RGB SS Lights
<---(port 2/of/16)-----> SSC2 <----------> RGB SS Lights
<---(PN(out#2)----> SS-HUB2
<---(DMX512 out)----> (on pixelnet universe selected, usually on ch#1-512)
(do not assign pixelnet channels to the first 512 if
using DMX channels as they are SHARED, basically
pixelnet channels work fine but are also being
converted to DMX on the DMX-out port for the
DMX universe selected via. jumper, normally 1)
Sometimes the connection to the PC looks like this instead:
PC <---network---> Hub or router <-------> Lynx Etherdongle <------> SS-HUB
OR
PC <---network---> Hub or router <-------> Lynx Etherdongle#1 (first 16k channels) <------>
<--------> Lynx Etherdongle#2 (second 16k channels) <----->
One powerful thing I discovered was that I could hook up a Lynx DMX Tx to the Active Hub DMX512 out port.
What this did was allow me to put all those 512 DMX channels into wireless real quick.
Then by added a Lynx Ex/Rx board to each Lynx Express, they could get their DMX signal from the Lynx Tx and I basically could control a bunch of express controllers wirelessly. I run them up to the roof, across to my neighbors house ... never had an issue with range at all. You can also go back to a wired connection from a Lynx Express if you want, so I do this a lot:
SS-HUB ----(DMX512 out port)-----> Lynx Tx ----->> (wireless)
(wireless) <<------- Lynx Express#1 <---cat5---> LE#2 (wired) <---> LE#3
w/Ex/Rx board
(wireless) <<------- Lynx Express#4
w/Ex/Rx board
You really need to spend some time watching the videos to understand it properly. I bet many others have done videos, but these are the ones I know of.
Check out the WIKI page on Smart Strings:
You are not allowed to view links.
Register or
LoginI would honestly watch Sean' videos on xlights/nutcracker for the setup on that side. Its really quite simple.
You are not allowed to view links.
Register or
LoginFor an overview of the Lynx boards and Smart Strings -- watch RJ' videos. You can look at many more once you are on his vimeo page (just click on videos).
You are not allowed to view links.
Register or
LoginLone Star Academy Presentation by RJ -- excellent overview!
You are not allowed to view links.
Register or
LoginThese older videos that RJ did are very helpful as an introduction to smart strings and the lynx hardware in general. Keep in mind that software utilities and boards have undergone minor enhancements since then, but the basic operation is pretty much the same.
This video shows the basics of smart strings, its a bit dated (showing a USB dongle instead of an etherdongle).
You are not allowed to view links.
Register or
LoginThis video shows the basics of a SS hub, controller and hooked up to an etherdongle I believe. It's a bit dated, but should still be accurate. You can test this stuff using xlights in the test tab (assuming you have done the setup tab first).
You are not allowed to view links.
Register or
LoginWalkthrough of RJ' show from a few years back.
You are not allowed to view links.
Register or
LoginNewer stuff:
Using the Conductor:
You are not allowed to view links.
Register or
Login