All DMX devices have some method by which you set the start address. The DMX signal is not altered by the receiving device. I don't know about the renard stuff, but if it is configured for DMX, it too has some way that you can set the address.
RM
Yes RM, you are correct you can set the start address for a Renard Device, but the way that Renards handle DMX is not how regular DMX devices handle it. The Renard actually removes the channels it uses and only transmits out the left over channels. Also since the Renards strip the channels if you set the first one with the start address you want in DMX, then any Renards you daisy chain after will continue to consume channels in order (if each daisy chained Renard has a start address of 1). I am not sure if there would be an issue if you started at some random channel. Would the daisy chained renard still consume in order after the first Renard? It should but I think the safest way is to set the start address of every Renard that is running DMX.
here a quick question ... i will be runnign lynx wireless to my mega tree but i want to add a ren 24ss to it too ,,,,that cable pin out should work right ??
First are you running Lynx wireless on an Express then DMX out to a Renard. If so than yes the above posted pinout is requried since the Renard does not use the standard pinout for DMX through a cat5 jack. The easiest way is to make a cat5 adapter with a short piece of cat 5 cable with a rj45 jack on one end and then run the other end to a punch down keystone jack with the appropriate wires to the correct places. Check monoprice.com for cheap keystone jacks and punch down tool.
If you are running Lynx wireless straight into the Renard the pinout does not matter going into the Renard because you bypass the cat5 jack with the EX/RX using the wireless mod. See my other post about Lynx wireless to a Renard:
You are not allowed to view links.
Register or
Login now this is what i want to do ..i want to have 5 set up like that ...wireless with ren attache to it ....is that mean i can have first set up lynx/ren24ss from 1-16 than 17 -41 ..then adjust the adress starting point on my second lynx/ren set up from 42-57 then the ren will be 58-82 ..ect ect ??
Yes you can run the channels for the Renard any where you want, as I stated above you are safest to set the start address of every Renard to make sure you dont have problems.
or will i have to change all my vixen order ??
Vixen doesn't care where the devices are, it just transmits the data and the device with that start address starts reading it from the channel you specified.
i understand that the lynx can have the chanell starting point at what ever i want ( wicht is very cool ) but will it work the way i am planning or is there a easier way ?
thanks
Looks like your plans will work, remember the Renard DMX firmware is where you have to program the starting address. The first pic gets the start address you want and every other pic on that board gets a DMX start address of 1