I have set up a 25x25 matrix as was discussed in a previous post. It is vertical matrix and I ran the lights from the bottom left corner zigzaging my way up and down to get 25 nice little rows and columns on my matrix. I defined it in xLights in this manner as well. There are 5 controllers used in this matrix; each with 128 nodes (this does put 15 extra nodes outside the matrix; I just haven't cut them off).
When I run a Bar pattern using xlights the link below shows what I get.
For what ever reason the 3rd and 5th controllers are behaving differently than the other controllers. I have checked to make sure they are not in hybrid or grouped mode when programmed. The controllers are set to the proper channel counts. Also note that although the matrix has 625 nodes; the last string I didn't cut short so there are 15 nodes left over. However, 12 of the 15 nodes light up and this can be seen if you look for the dangling nodes to the right.
Any ideas?
You are not allowed to view links.
Register or
LoginThe video shows bars running top to bottom and then Right to Left.
Please note, I just uploaded the video and am not a "plus" member so the video may not have processed by the time you click the link. Sorry.