I've built my Z16, but I'm not having any luck getting the lights to come on. Here is what I've done so far
1. Tested my Etd and string of lights using an active hub and a V3 SSC. All good
2. Reflashed my pic for position 1 using an SSC V4 that has no cables attached. verify looks ok, checksum looks ok
3. Put the chip back into the Zeus and ran the new programming utility (V2) to program the firmware. Lights flash all white.
4. Power off the Zeus, move the program jumper to off, exit the programming utility, and repower up the Zeus
5. Bring up xlights test, select output to lights, select all channels, go to RGB, background only and try try the sliders. This test works fine if connected to the active hub and SSC.
6. I've tried this with terminate on and off. neither works
Now I'm stumped. I've tried reflashing the firmware and reprogramming the chip and still cannot get lights to come on using xlights. Probably something my feeble old brain is missing.