Hey DLAers, I just finished 1 Aether and did the wireless Mod a little Different tell me what you think. First the reason for this is to be able to remove the EX/RX with out desoldering anything I stink at that.
1) 2 pin header on Manual , one end of the servo plugs on
2) 517-974-01-04 on the wireless pulled 1 pin out installed on Aether servo plugs on
3) Split black lead from servo comeing from aether cut and soldered another servo on (removed red and white on the servo that was solder on)
4) Built wireless EX/RX just as if you were going to use it on a LE Now just plug wires from Aether in EX/RX
The reason I did this is now I can swap my EX/RX out of a LE or Aether it just unplugs this is not tested yet do you see any problems with this set up