I have read all the posts & rerun the program 8-10 times always with the same results. I have a red & green LED on solid hook up a LED test strip to ch 1,2,3. I am using CAT5 to connect to the board so org strip, green strip, brown strip are together & connected to the + side of the boards. Then the Or. solid is connected to ch1 (red) blue solid to ch 2 (green) brown solid to ch 3( blue). When I plug the controller back in I get a solid Blue on the led whit no program running. That should tell me that the address did not take correct? As said above have done this many times with same results. Below are a couple pictures.
Thanks Mike