Rick or RJ,
Do you know if this is correct? If so, would it take much to change the firmware to make the channel arrangements consistent between versions?
Thanks,
-Paul
Hi Paul,
To be honest I don't own any aethers
But following normal RJ logic they both should work the same way (similar firmware ). They both should be RGBW units.
Could there be a assembly problem with the Aether I?
Can you control the aether I properly? Like just Red on or Green or Blue, etc?
From RJ about the Aether I - Feb 18 2010
It will be 4 channels, It will have Red, Green, Blue and White as independant channels. When the white channel is active the other channels will be ignored and and the light follows curves to ramp up and down white light. When you ramp white back down if the color channels are still on the light goes back to that color as soon as the white channel hits zero.
So in other words the 4th channel is a white overide.
So maybe some trouble shooting is needed.
Rick R.