No joy with Jeff's sequence.
So, to bring everyone up to date:
Vixen 2.1.4 -> Lynx_EtherDongle 2.1 plugin -> cat5 cable -> ETD -> cat5 cable -> LE
VIXEN:
o 2048 channel sequence
o EtherDongle plugin
o random sparkle set up in channels 1-16
ETD:
o all chips installed correctly
o power LED is on
o eNet jack link LED is on
o eNet data LED blinks when sequence running
LE:
o PIC chip successfully flashed for DMX
o all chips installed correctly
o when on-board test is run, LED3/DMX is lit
o data link LED lit (when Cat5 connected)
o 5v OK LED lit
o 3.3v OK LED lit
o 7-segment LED reads "001"
o terminator and power jumpers are bridged
o no lights connected to 120v outputs yet
When running sequence, Laptop and ETD eNet jack data LEDs blink but no other activity.
A BIG NOTE: I have yet to attach a load to the LE. I've just been relying on the channel LED's to light up as they do during the on-board diagnostic.