I have a newly built LE Version 5. The 3.3 and 5.0 light up and when I press the select button channel 16 will light. I have programmed the chip, but there is no display and no self test. I have checked the solder joints and and they seem to be okay, but I did have a hard time soldering the middle leg of the Triacs and these joints leave a lot to be desired. I have power to both sides of the boards. I have the little do hickeys on for "terminate" and the one for "Remove for wireless." I am not using wireless.
Any suggestions would be greatly appreciated.
Sincerely,
Danny