DiyLightAnimation
Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Home
Wiki
Blog
Chat
Help
Login
Register
DiyLightAnimation
»
Forum Info
»
Getting started with Light Animation
»
lynx express PCB and CG1500 enclosure
« previous
next »
Print
Pages: [
1
]
Author
Topic: lynx express PCB and CG1500 enclosure (Read 2620 times)
lashbyrn
Full Member
Posts: 58
lynx express PCB and CG1500 enclosure
«
on:
August 14, 2012, »
I just received my shipment of 6 CG 1500 enclosures from WLC. I was surprised to find out that only 1 screw hole on the Lynx express PCB would line up with the 76 mounting bosses provided in the cases. Looks like i will be making adapter plates. Any ideas on doing that?
Logged
urthegman
Sr. Member
Posts: 960
Re: lynx express PCB and CG1500 enclosure
«
Reply #1 on:
August 14, 2012, »
I made some 1/4" strips of wood that are an inch and a half wide and covered the tops of the screws that I used to hold them in place with electrical tape.
Logged
kjam22
Sr. Member
Posts: 170
Re: lynx express PCB and CG1500 enclosure
«
Reply #2 on:
August 14, 2012, »
I drilled through the back of the case and mounted a bolt, then on the inside I used a nut on each side of the board to lock it in place. I may have a picture somewhere, I will have to look.
Logged
chrisatpsu
Sr. Member
Posts: 3729
ahhh, yes... my new blink-i-nator 3000!!!
Re: lynx express PCB and CG1500 enclosure
«
Reply #3 on:
August 25, 2012, »
the manufaturer of the enclosures make changes to the enclosures to changing specifications in the telephone and cable industries. you have the new design.
Logged
To rule the entire tri-state area! What's that? Perry the Platypus!!!
Print
Pages: [
1
]
« previous
next »
DiyLightAnimation
»
Forum Info
»
Getting started with Light Animation
»
lynx express PCB and CG1500 enclosure