Call it weary at this point, but I have attempted to ID 2 SSR4s and both are not acting like they should. I have attempted to follow the Manual and the post down a ways: You are not allowed to view links.
Register or
Login.
So here is my set up. SSR4s for DMX. Wanting to set the ID to 301. No jumpers is on "S" or Terminate. Move Jumper to "C".
I know the dongle is active, I have checked a LE with it.
After trying both ways, moving the jumper with power off, or power on, then using the Lynx Deck to check, nothing on Channel 1. I have attempted this on 2 SSR4s at this point. I am wanting to slave these and make them both ID 301.
I am purty dang sure I programmed the PIC back when I assembled the unit this summer, but I will re-flash it tomorrow just in case.
I know something is happening, cause when I have a light string plugged into CH1, when programming, they light. Maybe I am missing something obvious. See anything?