Fellas, I just want to let you all know that the level of complexity is a little higher on this device than with some of other builds. This servo controller has some options such as single power supply vs. split power supply etc. The board is rather densely populated to keep it small. Not to mention the need to choose an appropriate sized power supply and how to use the programmer software for assigning channels and servo travel limits.
Mike will document the technical build with the options.
I will put together some documentation for how to use the programmer.
This device is very feature-rich, so the demands on technical ability rises in proportion to that. Just want to set your expectations. I may be overstating, but better than surprising you with any difficulty.
For those who haven't done so yet, please go back and read this thread. A lot of the details are sprinkled throughout. It would be a good start to getting familiar while you're preparing to do the build.
Dave