I'm trying to use the config program to set light curves and the channel.
This is a new LE, I can set the channel using the push buttons. I can also see DMX successfully control the board by turning on lights.
The manual, and the instructions above are a little mixed up... for example:
Note Next two steps are swappable. - Put your Express in prg mode by hitting the mode button and when "PRG" shows up hit the edit button to turn the decimal on the right on. It should show "PRG."
- Now hit the Program button and the express should program and reboot.
The windows program will stay in transmit mode until you click on the stop button. This allows you to walk around your yard and program all of your Expresses if needed.
This are constructive suggestions...
I think the word "
edit" above should be "Select"
Also, when working with two components, its useful to identify what is being referred to... especially if the terminology is similar at both ends...
"
Now At the computer hit the Program button and the express should program and reboot. "
Next... the link to the video demonstrating the config utility no longer works. This is a problem in the posting above, and also in the manual.
You are not allowed to view links.
Register or
Login Another problem... on my windows 7 machine I found that the utility aborted each time until I ran it as administrator.
Back to my original problem... I press Mode-then-Select getting the "PRG." state... I use the utility to set the COM port, the desired channel, and the curve info... I press "Program" at the utility but nothing happens at the LE... not blinky (like a SSC), the LED panel remains unchanged, and it does not reboot.
Suggestions?