Ok, this may have nothing to do with the firmware, but I have been having problems with my LE v4.
I just finished building it, and when I plug it in, sometimes the LED display does not display anything at all, but if I press the MODE button twice, and then hit select, it runes thru the test, but the display does work about 9/10 times. I also am having problems with channel 5,6, and 7. I run the test multipule times, and channel 5 worked all but once. The LED on channel 6 flickers and fades in and out, and usually doesnt work at all but the lights I have pluged into channel 6 are always on, and then I don't get anything on channel 7. I am working on doing some re-soldering joint, maybe some of the first joints I made when I first started building the board did not work right.
Would this have anything to do with the firmware, or just bad soldering.
I just got a new soldering iron yesterday, and it works way better than the old on I had, and I dont have solder balls all over the board.
Any help?
Thanks,
Jesse