OK, I kind of did a bit of both. I added a section at the end of the original sequence that blacked out my trees, that worked, the sequence did run to its end on the schedule. However I also have roofline on which I didnt want to go out at all during the sequence so I added a second schedule, two minutes after the first ended with all channels at zero. It didnt run, I got an error message about not being able to connect to Com 5 which is the port the dongle is plugged into.
In the scheduler it shows 30 minute increments in the time, the fact I put 11.02pm as the start time maybe confused it?
any thoughts?