There really is not a manual for this request.
I will chime in with a few known issues you can try to resolve.
No communication between Ed and LE (or any device)
Solutions:
1. is to make sure you have all the drivers installed.
2. you may need a crossover or in expensive router (I use this method) to create an IP. This is very true with an older computer.
If not give use some very good pictures of both sides of the board.
What are you using to program you PIC?
I am sure there will be more questions for you soon. Most problems are solved by the best questions asked.
Kevin
Well first off
?
I am REALLY Network challenged.
Communication - the board lights up - green led and the magic jack flashes so I guess it is communicating. I can not figure how or where to look to see if the ED is communicating to anything. I do see a Realtec network icon in the windows network sharing center.
The ED is connected to my laptop. ED output to SS hub all set to universe 1.
Pickit 3 was used to program the PIC and checksum is correct (pixelnet)
I do not believe there is a board problem at this point because I have no clue how to setup the ED - check it - test it - and make it blink lights. BTW Vixen is setup with the plugin for the ED.
I do not know how to set up the network for the ED.
Pete