I thought I would write up a little list of the common troubles and how to fix them.
Bill's trouble shooting Guide,
Channel staying on, Check Solder joints, remove Solder spill over
Channel staying off, Check Solder Joints, make sure you use enough solder and have good heat
DMX not working, Check Solder Joints, make sure you use enough solder and have good heat
LEDs not lighting, Check Solder Joints, make sure you use enough solder and have good heat
Self test not working, Check Solder Joints, make sure you use enough solder and have good heat
Sporatic Light ons, Check Solder joints, remove Solder spill over
Wireless not working, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
Dongle Not working, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
Transmitter Not working, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
Receiver Not working, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
It was working but not now, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
It wasn't working but if I power cycle it it works for a while, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
It works sometimes, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
When it is wet it doesn't work, Let it dry out, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
The dog bit the cord, not it doesn't work, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat , replace cord.
The breaker tripped and now it doesn't work, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat Reset breaker.
Wife is Mad about the light show running too long, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat
I'm hungry, Check Solder joints, remove Solder spill over, make sure you use enough solder and have good heat, go eat.
*SMILE*